Cycles; Options; Modifiers - Kenmore Gas Dryer 110.7506 Use & Care Manual

Air Dry
Air Dry gives you all the benefits of hang drying with a shorter
drying time. Adjust the Air Dry cycle from 1 to 99 minutes at any
time during the cycle, or use the preset setting of 30 minutes.
Use the Air Dry cycle for items that require drying without heat
such as rubber, plastic and heat-sensitive fabrics. This chart
shows examples of items that can be dried using the Air Dry
cycle.
Type of Load Minutes*
Foam rubber - pillows, padded bras, stuffed toys 20 - 30
Plastic - Shower curtains, tablecloths 20 - 30
Rubber-backed rugs 40 - 50
Olefin, polypropylene, sheer nylon 10 - 20
*Reset time as needed to complete drying.
When using Air Dry
• Check to see that coverings are securely stitched.
• Shake and fluff pillows by hand periodically during the cycle.
• Dry item completely. Foam rubber pillows are slow to dry.
NOTE: An Auto Dry Level selection is not available when using
the Air Dry cycle.
Custom Program
Use the Custom Program to select the Cycle, Options and
Modifiers you use most frequently and store them for future use.
To store a cycle for future use
1. Select a Cycle.
2. Select the desired Options.
3. Select the desired Modifiers.
4. Press and hold CUSTOM PROGRAM for 3 seconds until you
hear a beep.
5. Press START.
To reuse this cycle
1. Press CUSTOM PROGRAM.
2. Press START.
You can customize your cycles by selecting options.
OPTIONS
¢'_ Wrinkle
Guard
¢_ Damp Dr'/
Signa_
(AutoC/<les 0 ,11y)
Damp Dry Signal
Select the Damp Dry Signal to alert you with an audible sound
that your clothes are approximately 80% dry. This is useful when
you want to remove lightweight items in a mixed load (to prevent
overdrying), or remove partially dry items that may need ironing.
NOTE: The Damp Dry Signal is an option that is only available
with Auto Dry Cycle.
WRINKLE GUARD ®
WRINKLE GUARD _ prevents wrinkles that form when you cannot
unload the dryer promptly at the end of a cycle.
• Press WRINKLE GUARD _ to get up to 21/2hours of heat-free,
periodic tumbling at the end of a cycle.
• Stop WRINKLE GUARD ® at any time by pressing the
WRINKLE GUARD ®pad or opening the dryer door.
• For the Casual Auto Dry cycle, WRINKLE GUARD ® is preset
to "ON." The other Auto Dry cycles will retain the WRINKLE
GUARD _ setting. (For example, if you select WRINKLE
GUARD _ in the Normal cycle, WRINKLE GUARD ®will be on
the next time you select the Normal cycle.)
NOTE: If you do not select WRINKLE GUARD ® , the dryer stops
after Cool Down.
When you select a cycle, the preset Auto Dry Level (Auto Dry) or
Manual Dry settings for that cycle will glow. Modifiers allow you
to change the preset settings and further customize your cycles.
Auto Dry Level with Ultra Moisture Sensing
Auto Dry Level with Ultra Moisture Sensing provides the most
accurate drying results in the shortest time. This can help you
save money on utility bills and reduce the risk of fabric damage.
Dryness level is determined by dual sensor strips that measure
the moisture in your clothes. Once the desired dryness level is
reached, the electronic sensors signal the dryer to stop to
prevent overdrying your clothes.
MODIFIERS
More
Time
More
Norrna_
Less
Time
Less
0 Loud
O soft
Auto Dry _"--,_-/O 0ff
Level
Auto DW L_cles Sigr_al Volume
For all Auto Dry cycles, the Auto Dry Level is automatically set at
Normal. This setting provides the recommended fabric care for
your cycle. The display will show the estimated time (in minutes)
required to reach an approximate 80% dry level. After the 80%
dryness level is reached, the remaining drying time required will
be displayed as actual time remaining.
Use the Normal setting to dry most loads. At the end of the cycle,
feel the dried clothes.
• If they are damper than you like, select a setting above
Normal the next time you dry a similar load.
• If they are drier than you like, select a setting below Normal
the next time you dry a similar load.
To change the dryness level
Press AUTO DRY LEVEL until the desired dryness level glows.
NOTE: Auto Dry Level is not a selectable option with the
EXPRESS DRY
TM
cycle, the Air Dry cycle or Touch Up.
To change from estimated to actual drying time
Press MORE TIME or LESS TIME until the desired time is
displayed. The light for Timed Dry (Actual) will glow.
16