Table of Contents
Advertisement
Surface burnerand grill modules.
Throughout this manual, features and appearance may vary from your model
Sealed Burner Module
ToInstall the Sealed Burner Module:
1. Make sure that all control
knobs
are
set to OFF.
2. Clean tile cooktop
basin to remove
any grease
accumulation.
See tile Care
and Cleaning the Cooktop secdon.
3. _'ith
tile back of tile bm'ner
module
tilted up and tile mixer tube openings
and ignitor
rods fl_cing tile orifices
and tem/inal
receptacle,
insert tile
module
in tile cooktop
basin.
4. Slide
tile bm'ner
module
fin'ward
tmfil
tile tubes
and
ignitm_
start
to engage.
5.
I,ower
tile back
_d tile module
into
place
and
careliflly
slide
it fin'ward
tmtil
tile mixer
robes
and
ignitor
rods
are
fidly engaged.
ToRemove the Sealed Burner Module:
l,
2.
Make sm'e that all control
knobs
are
set to Off'and
that the cooktop
is cool.
i,ifi up tile edge of tile bm'ner
module
tmtil tile bottom
of tile module
clea_
tile edge of tile basin.
IMPORTANT'. 0o not lift the module too
high while it is still connected--you
could
damage the ignitor rods and mixer tubes.
3. Hold tile module
by tile sides and pull
it away fl'om tile temfinal
receptacle
and orifices, i,ifi it out of tile basin
when it is completely
mq)lugged.
4. Do not store or stack modules
where
they could fifll or be damaged.
NOTE:The optional
sealed bm'ner
moduleJXGB79
can replace
tile grill
burner
assembl_:
Grill Module
The grill consists of two black grill grates and the grill burner. Only install the grill on the left
side of your cooktop.
ToInstall the Grill Module:
l,
2.
3,
Make sm'e that all control
knobs
are
set to
OFF.
Position
tile grill bm'ner
Mth
tile
mixer
robes
and
ignitor
rod
ti_cing
tile
orifices
and
temfinal
_eceptacle.
Slide
tile grill burner
fin'ward
until
tile
tubes
and
ignitols
are
engaged;
then
lower
the 1)urner
tmtil
it rests
on the
motmting
pins.
4. Careflflly place tile grill grates on tile
cooktop.
NOTE:Before using the grill for the first time,
heat the grill burner to removethe protective
shipping coating.Heat thegrill bumer on HI
for 10minutes and usethe vent systemto
remove any additionalsmoke during cooling.
10
ToRemove the Grill Module:
1. Make sm'e that all control
knobs
are
set to OFFand all grill conli)onents
are
cool.
2,
3.
Rem_we tile grill grates.
I,ifl tile grill bm'ner
up slightly and
pull it away from tile temdnal
receptacle
and orifices, i,ifl it out of
the basin when it is completely
tmplugged.
4. Do
not
stoFe
or
stnck
ii/o(hlles
wheI'e
they could tifll or be damaged.
NOTE:The optional
sealed burner
module.]XGB79
can replace
tile grill
burner
assembl_:
Advertisement
Table of Contents
