Grill Module - GE JGP990 Installation & Owner's Instructions

Surfaceburnerandgrill modules.
Throughout this manual, features and appearance may vary from your model.
Sealed Burner Module
ToInstall the Sealed Burner Module:
1. Make sure that all control knobs are
set to OFF.
2. Clean tile cooktop basin to remove
any grease accunnllafion.
See tile Care
and Cleaning the Cooktop secdon.
24. With tile back of tile btlFneI" illodtlle
tilted up and tile two ro/md openings
and th tee pins ti_cing t()wa rd the front,
inse_t tile module in tile cooktop basin.
4. Slide tile bm'ner module forward tmfil
the pins start to engage the white
slotted receptacle,
5. I,ower tile back of tile module into
place and carefiflly slide it fin'ward
tmtil tile pins are flflly engaged.
6. Place tile burner caps on tile burne_.
Careflflly place tile grate onto tile
module with tile two tabs on tile
trade,side toward tile center of
tile cooktop.
ToRemove the Sealed Burner Module:
1.
2.
Make sm'e that all control knobs are
set to OFFand that tile cooktop is cool.
i,ifl up tile edge of tile bm'ner module
tmtil tile bottom of tile module clem_
tile edge of tile basin.
IMPORTANT. Do not lift the module too
high while it is still connected--you could
damage the ignitor rods and mixer tubes.
3. Hold tile module by tile sides and pull
it away fl'om tile slotted receptacle and
brass orifices. Lift it ()tit of tile basin
when it is completely m_plugged.
4. Do not store or stack modules where
they could
edl
or be dalnaged.
NOTE: Tile optional sealed b/m_er
moduleJXGB90 can replace tile grill
burner assembly:
10
Grill Module
The grill consists of a black grill grate and the grill burner. Only install the grill on the left side
of your cooktop.
ToInstall the Grill Module:
1.
2.
3.
Make sm'e that all control knobs are
set to OFF.
Position tile grill burner Mth tile
two rotmd robes and three pins ti_cing
tile fl'ont.
Slide tile grill bm'ner fin'ward tmfil tile
pins and ignito_s are engaged in tile
white slotted receptacle; then lower
tile burner tmtil it rests on tile
m otmting pins.
4. Careflllly place tile grill grate on tile
cooktop. Tile grate is designed to fit
one way only. See tile illustration.
NOTE: Before using the grill for the first time,
heat the grill burner to removethe protective
shipping coating.Heat the grill burner on HI
for 10minutes and use the vent systemto
remove any additionalsmoke during cooling.
ToRemove the GrillModule'.
2.
3.
Make sm'e that all control knobs are
set to OFFand
all grill
components
are cool
Remo\e tile grill grate.
I,ifl tile grill burner up slightly and
pull it away flora tile white slotted
receptacle and brass orifices. Lift it out
of the basin when it is completely
unplugged.
4. Do not store or stack modules
where
tile)' could iidl or be damaged.
NOTE: Tile optional sealed burner
moduleJXGg90 can replace tile grill
burner assembly.