GE JGP979 Owner's Manual page 26

Installation Instructions
[] ELECTRICAL CONNECTION
Electrical requirements:
120-volt, 60-Hertz, individual, properly grounded
branch circuit protected by a 15-amp circuit
breaker or time-delay tilse.
GROUNDING
IMPORTANT:
(Please read careflflly.) FOR
PERSONAl, SAFETY, THIS APPI,IANCE MUST
BE PROPEI),I,Y GROUNDED.
The power cord of this appliance is equipped
with a three-prong (grounding) i_lug which mates
with a standard three-prong grotmding wall
receptacle to minimize the possibility of electric
shock hazard ti'om this appliance. The customer
should have the wall receptacle and circtfit
checked bv a qualified electrician to make sm'e
the receptacle is properly grounded and has
correct polarity.
Where a standard two-prong wall receptacle is
encotmtered, it is the personal responsibility and
obligation of the customer to have it replaced
with a properly grotmded three-prong wall
receptacle in accordance with the National
Electrical Code.
Do Not, Under Any Circumstances, Cut Or
Remove The Third (Ground) Prong From The
Power Cord.
Do not use an extension cord with this appliance.
[] CHECK IGNITION
After installing the cooktop, check the ignition ot
each bm'ner.
1. Push in one knob and turn to the I,]TE
position (180 ° from OFF). The igniter will
spark and the bm'ner will light.
2. Afier the bm'ner is lit, turn the knob to HI and
the igniter will stop sparking.
3. Tm'n the knob to the OFF position.
Repeat this for each bm'ner.
NOTE: If flames are yellow or too lo_, reter to the
Troubleshooting Tips section in this manual.
26