Dell XPS 710 Service Manual page 49

Activity light (on integrated network adapter)
Diagnostic lights
Standby power light
front panel LEDs
back panel LEDs
Power
DC power supply:
Wattage
Heat dissipation
Voltage (see the safety instructions located in
the Product Information Guide)
Backup battery
Physical
Height
Without stand
With stand
Width
Without stand
With stand
Depth
Weight
Typical configuration
Maximum configuration
Environmental
Temperature:
Operating
Storage
Relative humidity
Maximum vibration:
Operating
Storage
GB (1000-Mbps) network and the computer.
off (no light) — The computer is not detecting a
physical connection to the network.
yellow blinking light when there is activity on the
network; if there is not any network activity, the light
will be off
four lights on the front panel (see
AUXPWR on the system board
eight multi-colored LEDs provide illumination for the
front of the computer
NOTE: The color of the front panel LEDs can be
adjusted in system setup (see System
two multi-colored lights provide illumination for the
I/O panel on the back of the computer
NOTE: The color of the back panel LEDs can be
adjusted in system setup (see System
CAUTION: To reduce the risk of fire, electric shock,
or injury, do not overload an electrical outlet,
power strip, or convenience receptacle. The total
ampere rating of all products plugged into an
electrical outlet, power strip, or other receptacle
should not not exceed 80 percent of the branch
circuit rating.
750 W or
1 KW
750 W: 2559 BTU/hr or
1 KW: 3412 BTU/hr
NOTE: Heat dissipation is calculated based upon the
power supply wattage rating.
auto-sensing power supply—90 V to 265 V at 50/60
Hz
3-V CR2032 lithium coin cell
55.5 cm (21.9 inches)
57.2 cm (22.5 inches)
21.9 cm (8.6 inches)
35.6 cm (14.0 inches)
59.4 cm (23.4 inches)
21.7 kg (47.8 lb)
25.6 kg (56.4 lb)
10° to 35°C (50° to 95°F)
–40° to 65°C (–40° to 149°F)
20% to 80% (noncondensing)
0.25 G at 3 to 200 Hz at 0.5 octave/min
0.5 G at 3 to 200 Hz at 1 octave/min
Diagnostic Lights)
Setup).
Setup).