Removing The Computer Stand - Dell XPS 710 Service Manual
Hide thumbs
Also See for XPS 710:
- Quick setup manual (2 pages) ,
- Owner's manual (182 pages) ,
- Owner's manual (106 pages)
Table of Contents
Advertisement
8. Connect your computer and devices to electrical outlets, and turn them on.
9. Enter system setup (see System Setup) and restore the settings you recorded in
10. Properly dispose of the old battery. See the Product Information Guide for battery disposal information.
Removing the Computer Stand
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
Your computer is heavy and can be difficult to maneuver. Seek assistance before attempting to lift, move, or tilt the computer and
always lift correctly to avoid injury; avoid bending over while lifting.
CAUTION:
The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the
computer tipping over, potentially resulting in bodily injury or damage to the computer.
1. Follow the procedures in
Before You
2. Loosen the captive screw securing the stand to the base of the computer.
3. Gently slide the stand back, towards the rear of the computer, then pull the stand away from the computer to remove it.
1
computer stand
Replacing the Computer Cover
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
Your computer is heavy and can be difficult to maneuver. Seek assistance before attempting to lift, move, or tilt the computer and
always lift correctly to avoid injury; avoid bending over while lifting.
CAUTION:
The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the
computer tipping over, potentially resulting in bodily injury or damage to the computer.
NOTICE:
To avoid electrostatic discharge and damage to internal components, ground yourself by using a wrist grounding strap or by periodically
touching an unpainted metal surface on the computer chassis.
1. Ensure that all cables are connected, and fold cables out of the way.
2. Ensure that no tools or extra parts are left inside the computer.
3. Pivot the cover down and into position.
Begin.
2
captive screw
step
1.
Advertisement
Table of Contents
