Table of Contents
Advertisement
1 pull tab
4 RJ11 internal connector
(RJ11INT)
4. Install the new modem:
a. Connect the T-shaped connector of the modem cable to the modem.
b. Align the modem with the screw holes and press the modem into its connector on the system board (see
NOTICE:
The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors for proper orientation, then try again.
c. Replace and tighten the two screws to secure the modem to the system board.
d. Replace the other end of the modem cable to the RJ11 internal connector.
5. Connect the power cable to the power connector (POWER) on the system board (see
6. Replace the hard drive (see
7. Replace the computer cover (see
Power Supply
Removing the Power Supply
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
1. Follow the procedures in
Before You
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTICE:
Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the
computer. While you work, periodically touch an unpainted metal surface to dissipate any static electricity that could harm internal components.
2. Disconnect the AC power cable from the power supply connector.
3. Disconnect all DC power cables from the system board and drives.
4. Remove the three power supply screws.
2 modem
3 screws (2)
cable
5 modem
6 T-shaped connector attached to the
modem cable
Installing a Hard
Drive).
Replacing the Computer
Cover).
Begin.
System Board
System Board
Components).
Components).
Advertisement
Table of Contents
