Power-Supply Unit; Removing The Power-Supply Unit - Dell OptiPlex Tower 7010 Owner's Manual

Steps
1. Insert the intrusion switch into its slot and slide the switch to secure it into the slot.
2. Route the intruder cable through the retention clip.
3. Connect the intruder cable to the connector on the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in

Power-supply unit

Removing the power-supply unit

CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following images indicate the location of the power-supply unit and provides a visual representation of the removal
procedure.
66 Removing and installing Field Replaceable Units (FRUs)
after working inside your
Before working inside your
computer.
computer.