Table of Contents
Advertisement
Steps
1. Slide the intrusion switch into the slot on the chassis.
2. Route the intrusion-switch cable through the routing guides on the chassis.
3. Connect the intrusion-switch cable to the connector on the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Power-supply unit
Removing the power-supply unit
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
2.5-inch hard drive
5. Remove the
3.5-inch hard drive
6. Remove the
disk-drive
About this task
The following image indicates the location of the power-supply unit and provides a visual representation of the removal
procedure.
After working inside your
Before working inside your
if applicable.
if applicable.
cage.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
73
Advertisement
Table of Contents
