Dell XPS 210 Service Manual page 36

Controls and Lights
Power control
Power light
Hard drive access light
Link integrity light (on integrated network adapter)
Activity light (on integrated network adapter)
Diagnostic lights
Standby power light
Activity light (optional Media Card Reader)
Power
DC power supply:
Wattage
Heat dissipation
Voltage (see the safety instructions in the
Product Information Guide for important voltage
setting information)
Backup battery
Physical
Height
Width
Depth
Weight
Environmental
Temperature:
Operating
Storage
Relative humidity
Maximum vibration:
Operating
Storage
Maximum shock:
Operating
Storage
Altitude:
Operating
Storage
Back to Contents Page
push button
green light — Blinking green in sleep state; solid
green for power-on state.
amber light — Blinking amber indicates a problem
with an installed device; solid amber indicates an
internal power problem (see "Power Problems" in
your computer Owner's Manual).
green
green light — A good connection exists between a
10-Mbps network and the computer.
orange light — A good connection exists between a
100-Mbps network and the computer.
off (no light) — The computer is not detecting a
physical connection to the network.
yellow blinking light
four lights on the front panel (see
for an explanation of the diagnostic light codes)
STBYLED on the system board
green blinking light
275 W
935 BTU/hr
manual selection power supplies — 90 to 135 V at
50/60 Hz; 180 to 265 V at 50/60 Hz
3-V CR2032 lithium coin cell
31.8 cm (12.5 inches)
9.4 cm (3.7 inches)
36.8 cm (14.5 inches)
6.89 kg (15.2 lb)
10° to 35°C (50° to 95°F)
–40° to 65°C (–40° to 149°F)
20% to 80% (noncondensing)
0.25 G at 3 to 200 Hz at 0.5 octave/min
0.5 G at 3 to 200 Hz at 1 octave/min
bottom half-sine pulse with a change in velocity of
50.8 cm/sec (20 in/sec)
27-G faired square wave with a velocity change of
508 cm/sec (200 in/sec)
–15.2 to 3048 m (–50 to 10,000 ft)
–15.2 to 10,668 m (–50 to 35,000 ft)
Diagnostic Lights