Gateway 450RGH Service Manual page 59

Replacing Gateway 450RGH Components
15
If the notebook has IEEE 802.11 wireless networking built in, loosen the screw
holding the antenna grounding wire, then lift the antenna grounding wire to remove
the screw.
16
Carefully pull the detached antenna cables up through the hole in the system board
near the touchpad.
Caution
17
Lift the LCD panel away from the notebook. The LCD panel assembly is now
completely detached from the notebook.
18
Place the new LCD panel assembly onto the notebook, then replace the four hinge
screws.
19
Reattach the LCD panel grounding cable and secure with the screw.
20
Thread the antenna cables through the guides on the LED indicator panel shielding,
then through the hole in the system board.
21
Reattach the antenna grounding cable and secure with the screw.
54
Antenna grounding screw
The connectors may catch on the system board hole. Be
careful not to break the connectors off the antenna cables.
www.gateway.com