Gateway 450RGH Service Manual page 41

Replacing Gateway 450RGH Components
10
Insert the small flat-blade screwdriver or non-marring tool under the left side of the
indicator panel and gently pry it up about ¼-inch, then lift the entire panel from
the notebook.
11
Carefully lift the middle of the silver EMI panel shielding slightly away from the
panel, then lift the ends slightly, then repeat until the shielding pulls completely free.
Caution
12
Align the new indicator panel screw holes with the holes on the notebook, then
press the panel into place.
13
Carefully replace the indicator panel shielding.
14
Replace the two top screws that secure the LED indicator panel to the notebook.
15
Align the connectors for the modem cable and antenna cables on the third screw,
then replace the screw to secure the LED indicator panel shield to the notebook.
Caution
16
Rethread the antenna cables (if applicable).
17
Reassemble the notebook. Replace the main battery and secondary battery (if
installed). Connect the AC adapter and modem and network cables, then turn on
the notebook.
36
The LED panel's metal shielding is very thin and will break
if you bend it too much. Be careful when handling the EMI
panel shielding.
The bottom screw also secures the cable for the modem
and the grounding wire for the wireless networking antenna
cables. Be careful not to damage the connectors or the
wires when installing this screw.
www.gateway.com