Auto On Function - Integra ADM-30.1 Instruction Manual

AUTO ON Function

Set the AUDIO SENSE and 12V TRIGGER switches in accordance with the intended use.
For Manual operation/
When not using
AUTO ON Function
When using only the
AUDIO SENSE
When using only the
12V TRIGGER
When using both the
AUDIO SENSE and
12V TRIGGER
8
Set both the AUDIO SENSE and 12V TRIGGER switches to OFF.
The ADM-30.1 can be turned ON/OFF using the POWER switch
on the front panel.
Set the AUDIO SENSE switch to ON and the 12V TRIGGER
switch to OFF. Pressing the POWER switch powers the ADM-30.1
up. However, if there is no signal for 10 minutes, the circuit turns
off to put the ADM-30.1 in the Ready state.
Then the circuit automatically turns on when an incoming Audio
signal is received. The ADM-30.1 switches between the On and
Ready states depending on the signal.
Set the AUDIO SENSE switch to OFF and the 12V TRIGGER
switch to ON.
When you press the POWER switch, the ADM-30.1 goes into the
Ready state waiting for a 12V TRIGGER signal.
Then the circuit automatically turns on when the 12V TRIGGER
signal is detected. The ADM-30.1 switches between the On and
Ready states depending on the signal.
Set the AUDIO SENSE switch to ON and the 12V TRIGGER
switch to ON.
When you press the POWER switch, the ADM-30.1 goes into the
Ready state waiting for a 12V TRIGGER signal.
Then the circuit automatically turns on when the 12V TRIGGER
signal is detected.
In this setting, even if the Audio signal has been input, the ADM-
30.1 goes into the Ready state unless the 12V TRIGGER signal is
input.
On the contrary, even if the 12V TRIGGER signal has been input,
the ADM-30.1 goes into the Ready state if there is no Audio signal
for 10 minutes.
For the ADM-30.1 to go from the Ready state to the On state, both
the 12V TRIGGER and Audio signals need to be input.