Front Panel Facilities And Connections - Integra ADM-30.1 Instruction Manual

Front panel facilities and connections

Power indicator
The Power indicator lights green when the ADM-
30.1 is turned on and the amplifier circuit is
activated, and lights red when the ADM-30.1 is in
the Ready state. The indicator goes off when the
ADM-30.1 is turned off.
POWER POWER
indicator switch
Off
9 9
Red
9
Green
Notes
- When the Power switch is set to Off, you cannot control the
on/off of the amplifier circuit from the connected devices. If
you want the amplifier circuit to be turned on/off by turning
on/off the connected devices, press the Power switch to the On
position to put the ADM-30.1 in the Ready state.
- When the AUDIO SENSE switch is ON and the 12V
TRIGGER switch is OFF, pressing the Power switch to the On
position turns on the ADM-30.1 and the Power indicator lights
green. If no audio signal is received for about 10 minutes, the
ADM-30.1 enters the Ready state and the Power indicator
lights red.
Audio output
Amplifier
OUTPUT
circuit
jacks
9
9 9
Power switch
This switch is used to turn the main power on/off.
The power state depends on the settings of the
AUDIO SENSE and 12V TRIGGER switches on
the rear panel. (See p.8)
SPEAKERS
No circuits are active.
The buffer amplifier between the INPUT
and OUTPUT jacks is functioning, which
allows the signal input at the INPUT jacks
to be directly output from the OUTPUT
jacks.
The AUDIO SENSE circuit is active.
9
All circuits are active.
Status
5