Integra ADM-30.1 Instruction Manual page 7

Rear panel facilities and connections
12V TRIGGER IN/OUT
Connect the 12V TRIGGER IN jack to an AV
Receiver that has a 12V TRIGGER output jack.
This jack works on between 5 to 12 volts DC. With
the Power switch of the ADM-30.1 set to On, you
can control the amplifier circuit using the controls
of the AV Receiver.
If you want another component to be activated/
deactivated by turning on/off the AV receiver
connected to the 12V TRIGGER IN jack of the
ADM-30.1, connect the 12V TRIGGER input jack
of that component to the 12V TRIGGER OUT jack
of the ADM-30.1. In this state, the 12V TRIGGER
is output when the ADM-30.1 is turned on.
Devices can be connected in series using these
jacks.
Use 1/8-inch (3.5mm) monaural-type mini-jack
connectors or the supplied stereo mini-plug cable.
The tip polarity of the connector is positive.
SPEAKERS
Connect the jacks on the speakers to the
SPEAKERS terminals using the speaker cables.
These terminals are compatible with banana plug
connections.
1 Strip away 12 ~ 15 mm (1/2"
insulation.
2 Twist wire ends very tight.
3 Unscrew.
4 Insert wire.
5 Screw.
12~15mm
1
( 1 / ˝ 5 / ˝ )
2 8
3 4
- Do not connect any devices other than speakers
to these terminals.
- Be sure not to mistake the positive and negative
outputs or the left and right speakers. Doing so
will result in an unnatural sound space.
- North American model:
Make sure to use speakers with an impedance of
2 to 16 Ohms.
If a speaker with an impedance of less than 2
ohms is connected, it may damage the ADM-
30.1.
Other models:
Make sure to use speakers with an impedance of
4 to 16 Ohms.
If a speaker with an impedance of less than 4
5/8") of wire
~
2
5
—Continued
ohms is connected, it may damage the ADM-
30.1.
- When you are using only one speaker or when
you wish to listen to monaural (mono) sound, a
single speaker should never be connected in par-
allel to both the right and left channel terminals
simultaneously.
+ – – +
R
- To prevent damage to circuitry, never short-cir-

cuit the positive ( ) and negative (
wire.
AC INLET
Plug the supplied power cord into this AC INLET
and then into the power outlet on the wall.
- Do not use a power cord other than the one sup-
plied with the ADM-30.1. The power cord sup-
plied is designed for use with the ADM-30.1 and
should not be used with any other device.
- Never disconnect the power cord from the
ADM-30.1 while the other end is plugged into
the wall outlet. Doing so may cause an electric
shock. Always connect by plugging into the wall
outlet last and disconnect by unplugging from
the wall outlet first.
L

) speaker
7