Rapid Resume Logic; Timer Mode - Avital AviStart 3200 Installation Manual

rapid resume logic

The Rapid Resume Logic feature ensures that when the security system is powered back up after power has been
disconnected, the system will resume the same state it was in before power was lost. For example, if power is
disconnected during a full trigger sequence, the system will still be in the full trigger sequence when power is
reconnected to the unit. If power is disconnected while the unit is disarmed, it will still be disarmed when power
is restored.

timer mode

This unit can be programmed to start and run the engine every three hours. The engine will run for the pro-
grammed run time and then shut down. After three hours, the unit will restart the engine. A maximum of six
cycles can occur.
IMPORTANT! Timer Mode should be used only in open areas. Never start and run the vehicle in an
enclosed space such as a garage or carport.
The same procedure may be used to enter or exit Timer Mode using the remote transmitter:
1. Remote start the vehicle.
2. Press and release the transmitter button(s) controlling Channel Two.
3. Press and release the transmitter button(s) controlling remote start operation.
When entering Timer Mode, the engine should shut down. The parking lights (if connected) will flash four times
and the engine will restart. The system is in Timer Mode. The engine may be allowed to run for its programmed
run time, or the transmitter can be used to shut down the engine. Either way, the remote start system will restart
the engine again in three hours. Timer Mode is exited automatically after the sixth run cycle.
Timer Mode can also be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition on.
Timer Mode will be exited and the parking lights will flash four times.
© 2000 Directed Electronics, Inc. Vista, CA
39