Rapid Resume Logic; Power Saver Mode - Avital 5103 Owner's Manual

Rapid resume logic

This Directed system will store its current state to non-volatile memory. If power
is lost and then reconnected the system will recall the stored state from memory.
This means if the unit is in Valet Mode and the battery is dis con nect ed for any
reason, such as servicing the car, when the battery is re con nect ed the unit will
still be in Valet Mode. This applies to all states of the system including arm,
disarm, and Valet Mode.

Power saver mode

Your system will automatically enter Power Saver Mode while armed or in Valet
Mode, after a period of time in which no operation has been performed. This
lowers the current draw on the vehicle's battery. Power Saver Mode takes over
under the following conditions:
• Power Saver when the system is armed: After the system has been armed
for 24 hours the LED will flash at half its normal rate, decreasing the sys-
tem's current draw.
• Power Saver in Valet Mode: When the system enters Valet Mode the LED
illuminates steadily. If the vehicle is not used (ignition is not turned on) for a
one hour period while the system is in Valet Mode, the LED will shut off. If
the system remains in Valet Mode, the LED will come back on the next time
the ignition is turned on and then back off.
© 2009 Directed Electronics. All rights reserved.
21