Table of Contents
Advertisement
Remote-Starting Your Vehicle
Setting Your Vehicle into Ready Mode
In order to start the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set
to Ready Mode, it cannot remote-start the vehicle.
Once the system is set to Ready Mode, the vehicle can be remote-started and stopped at wish.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the
position.
To set the system to Ready Mode:
1.
Ensure that all the doors are closed and that the gear selector is in the neutral position.
2.
With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3.
Within 20 sec. press and hold
The parking lights will flash 3 times quickly and remain lit.
4.
Remove the key: the engine will go on running.
5.
Exit the vehicle and close the door.
6.
Press for approx. 1 second either:
a.
to lock the doors and shut down the engine;
LOCK
b.
UNLOCK
c.
START/STOP
Remaining In Ready Mode
Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However, should
any of the following occur, the vehicle will exit Ready Mode – thus eliminating the remote start
option until Ready Mode is restored:
Door opened;
Hood opened;
Trunk opened;
Brake pedal pressed;
Parking brake disengaged;
Ignition key turned to the
Should any of the above occur, Ready Mode will be cancelled.
Note: The unit will notify the user that it has exited Ready Mode by giving 3 slow flashes
(parking lights).
To remote start your vehicle
Press the
START/STOP
transmitter will beep once to inform you that the remote starter has received your signal.
Approximately 5 seconds later, the engine will start. The transmitter will beep 3 times and the
parking lights will remain
If the vehicle does not start at the first attempt, the system will shut down.
Vehicle Presets
Heater & Heated Seats
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
instead.
P. 8
LOCK
to unlock the doors and shut down the engine;
to shut down the engine without affecting the doors.
IGNITION ON (RUN)
button for approx. 1 second. The parking lights will come
during the pre-programmed run time of the engine.
ON
. It is recommended to leave the settings on
HIGH
,
or
UNLOCK
START/STOP
position.
IGNITION ON (RUN)
on the transmitter.
ON
or
LOW
User Guide
and the
MEDIUM
Advertisement
Table of Contents
