Table of Contents
Advertisement
With many advanced functions, this product will satisfy any one your expectations from high-end
commodity and security systems, without neglecting any standard feature commonly offered by
entry-level starters.
Remote-Starting Your Vehicle
Remote-starting
Press the
button for approx. 1 second. The parking lights will come
START/STOP
control will play a melody to inform you that the System has received your signal. Approximately 5
seconds later, the engine will start. The parking lights will remain
run time of the engine.
If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are
of vehicles could cause them to remain
battery.
Driving Off
With the vehicle running under remote control, press the
doors. Enter the vehicle and do the following:
Turn the ignition key to the
IGNITION ON (RUN)
while the engine is running. This would cause the starter motor to re-engage.)
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Basic Vehicle Operation
The vehicle can be remote-started and stopped using the
button will open the trunk (if this feature is installed on the vehicle). The
(
) buttons will lock and unlock the doors of the vehicle (if the remote door lock feature is installed
on the vehicle) and arm or disarm the starter kill (if installed). The
access all advanced functions of the remote control. The AUXILIARY button (
activate AUX 2 or to Stop the engine (if programmed as the Stop button). (Refer to the LCD
Transmitter Operation tables.)
Alarm Clock
The LCD remote control has a built-in alarm clock that can be set up using the
Use the
and
buttons to switch the alarm clock on and off (refer to the tables).
P. 3
. It is recommended to leave the settings on
HIGH
. Leaving the headlight switch
OFF
even after remote starter shut down, resulting in a dead
ON
UNLOCK
position. (Do not turn the key to the
START/STOP
and the remote
ON
during the pre-programmed
ON
or
LOW
MEDIUM
on certain types
ON
button to disarm and unlock the
position
CRANK
( ) button. The
(
TRUNK
(
) and
LOCK
UNLOCK
(
) button is used to
FUNCTION
) is used to
button.
User Guide
)
Advertisement
Table of Contents
