Table of Contents
Advertisement
Safe Start
If this feature is enabled, the user must press the
remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing
with the transmitter.
If swap start mode is selected, to remote-start your vehicle, press the
simultaneously. The
Home Valet
TM
If this feature is installed, the user will have the possibility to remotely set the vehicle to a no-
remote-start mode. The alarm functions will still be active.
Turbo Mode
When left in turbo mode, the remote starter will keep the engine running for 60 seconds before
shutting it down. This is to allow a turbocharger to idle down after the user leaves the vehicle.
Engine Run Time
If you have a gas engine, your remote starter can be programmed to run the engine for 3, 15, or
25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).
Extended Run Time
While the vehicle is running under a remote start, pressing and holding the
for more than 3 seconds will reset the run time counter to zero and restart the run time cycle from
the beginning. There will be one beep a pause three more beeps; the parking lights will flash
three times. The extended run time procedure can only be carried out once per remote start.
To stop the vehicle, at any moment, simply press the
Example:
If your remote car starter is programmed for a run time of 4 minutes and your vehicle
has been running for 3 minutes already, pressing the
counter to zero and allow the engine to run for another cycle (in this case, 4 minutes).
Multi-car Operation
This option allows the owner of two vehicles, both equipped with the same remote starter model, to
control both systems with a single remote control. To control the second vehicle:
Press
TRUNK
Press
TRUNK
Press
TRUNK
Press
TRUNK
Press
SHIFT
or
Press
SHIFT
Press
SHIFT
Press
SHIFT
Press
SHIFT
Press
SHIFT
Note: In order to access the 2
pressed twice quickly and then one more time followed by
Note: If the multi-level features have been modified from their default state by your installer,
the
button may have to be pressed once, twice or three times, according to the option
SHIFT
you chose.
Shock Sense, Warn-away Sense
(Both enabled by default.) Your System will react to a full shock by triggering the alarm; it can also
respond to a lighter shock (30 % of the strength of a full shock) by giving a warn-away (without
triggering an alarm condition).
Note: After a remote start, although the shock sensor is disabled, all the other alarm-
triggering zones, such as the doors, the trunk or the hood, may still trigger an alarm.
P. 14
output can be activated by pressing the
AUX 2
+
buttons simultaneously:.........................
LOCK
+
simultaneously:.................................
UNLOCK
+
START/STOP
+
START/STOP
SHIFT
TRUNK:
SHIFT
LOCK
SHIFT
UNLOCK
SHIFT
START/STOP: ..................................................START
SHIFT
START/STOP:
SHIFT
TRUNK:
car operations with the companion remote, Shift button must be
nd
START/STOP
START/STOP
simultaneously
:...................................START
simultaneously
...........................
:
................................................
:..................................................
:.............................................
........................................
................................................
LOCK, UNLOCK, TRUNK
button 2 times within 3 seconds to
and
LOCK
UNLOCK
button.
START/STOP
START/STOP
button.
button will reset the
START/STOP
LOCK
UNLOCK
STOP
TRUNK
LOCK
UNLOCK
STOP
TRUNK
or
START
buttons
button
/
.
STOP
User Guide
Advertisement
Table of Contents
