Table of Contents
Advertisement
5.
Exit the vehicle and close the Door.
6.
Press the
door lock is installed).
If the pre-programmed run-time expires or if the user shuts down the engine by remote control, the
vehicle will get in Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Turbo Mode
If turbo mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine and set the Remote Car Starter to
Ready Mode.
Follow all steps of the Ready Mode routine, to activate Turbo Mode:
1.
Ensure that all the doors are closed and that the shifter is in the neutral position.
2.
With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3.
Within 20 sec. press
The parking lights will flash 3 times quickly and remain lit.
4.
Remove the key: the engine will go on running.
5.
Exit the vehicle and close the door.
6.
Press and hold either:
a.
LOCK
b.
UNLOCK
c.
START/STOP
(this will by-pass Turbo Mode).
D.
TRUNK TO SET THE VEHICLE INTO IDLE MODE
Valet Mode
Valet Mode Using the Valet Switch (if installed)
When your vehicle is in valet mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the valet mode will prevent the engine from being
remote-started accidentally.
To put the system i n t o valet mode:
1. Turn the ignition key to the
2. Within 3 sec., press the valet button.
The parking lights will flash three times to indicate that the vehicle is now in valet mode.
3. Turn the ignition key to the
The L.E.D. will come
To take the system o u t o f valet mode:
1. Turn the ignition key to the
2. Within 3 sec., press and release the valet button (the L.E.D. will come
The parking lights will flash twice to indicate that the vehicle is now out of valet mode.
The L.E.D. will go out.
Note: Once valet mode is activated, the remote starter and alarm functions will be disabled.
Ignition Valet
This feature will allow you to remotely put your system into valet mode by using the ignition key
instead of the valet button as above. Ignition valet can be used without a valet button installed.
To put the system i n t o valet mode:
P. 10
button until the system is armed (the doors will be locked if remote
TRUNK
,
LOCK
UNLOCK
to lock the doors and shut down the engine after 60 sec.;
to unlock the doors and shut down the engine after 60 sec.;
to shut down the engine immediately, without affecting the doors
IGNITION ON (RUN)
IGNITION OFF
solid.
ON
IGNITION ON (RUN)
or
on the transmitter.
START/STOP
position.
position.
position.
).
OUT
User Guide
Advertisement
Table of Contents
