Programming Transmitters - Audiovox XRO9100 Owner's Manual

PROGRAMMING TRANSMITTERS:

At times it may become necessary to program replacement or additional
transmitters for use with your system. To do this:
1) With the system unlocked or disarmed, turn the ignition key to the on
position.
2) Press and release the pushbutton switch three times
The unit will flash the parking lights and or beep the horn once to indicate that
the system is in the transmitter program mode. The LED will also flash one
time pause, one time pause, etc... indicating that you are in the transmitter
program mode of the unit's channel 1 or single button program mode.
3) Press and hold the lock button of each transmitter or additional transmitter
you wish to operate your system.
NOTE: The unit is capable of storing up to 4 transmitters. If a fifth transmitter
is added, the first transmitter programmed will be bumped out.
Once all transmitter have been programmed, turn the ignition switch off to exit
the program mode.
The system allows priority button programming in case you intend to operate
two vehicle with one transmitter. (Note: This is not necessary for the XRO92
OLED Transceiver) In this instance you will program the default button combi-
nation, (One Button Programming), for the main vehicle you drive, and a
different combination for the second vehicle so you are not unlocking, locking,
or starting both vehicles when they are within range of each other.
To prioritize transmitters after programming the transmitter into the first vehicle:
Enter the transmitter program of the second vehicle as above by:
1) With the system unlocked or disarmed, turn the ignition key to the on
position.
2) Press and release the pushbutton switch three times.
The unit will flash the parking lights and or beep the horn once to indicate that
the system is in the transmitter program mode. The LED will also flash one
time pause, one time pause, etc... indicating that you are in the transmitter
program mode of the unit's channel 1 or single button program mode.
3) Press and hold any combination of buttons of your transmitter that was not
used for your primary vehicle.
For instance, you can press & hold the lock & unlock buttons simultaneously,
for controlling Lock function of the second vehicle.
4) Press and release the program pushbutton switch once to advance to
channel 2, unlock.
Page 21
128-8261
21 of 24