Audiovox Prestige APS-25HJ Installation Manual
Audiovox Prestige APS-25HJ Installation Manual

Audiovox Prestige APS-25HJ Installation Manual

Audiovox prestige installation manual
Hide thumbs Also See for Prestige APS-25HJ:
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

RF Programmable Features :
Feature Selection
First
Second
Third
Fourth
Fifth
Sixth
Seventh
Eighth
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver's door pin switch in order to begin
the passive arming sequence.
To program these selectable features;
Action
Turn ignition on
Flip valet switch on then off 3 times
Within 3 seconds, turn ignition Off
First
Then On
Press transmitter button 1 to change
Second
Flip valet switch on then off
Press transmitter button 1 to change
Third
Flip valet switch on then off
Press transmitter button 1 to change
Fourth
Flip valet switch on then off
Press transmitter button 1 to change
Fifth
Flip valet switch on then off
Press transmitter button 1 to change
Sixth
Flip valet switch on then off
Press transmitter button 1 to change
Seventh
Flip valet switch on then off
Press transmitter button 1 to change
Eighth
Flip valet switch on then off
Press transmitter button 1 to change
Flip valet switch on then off
Turn the ignition switch off
Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the programming
will be terminated.

PROGRAMMABLE FEATURES

1 Chirp
1 Second Door Locks
Auto Lock On
Auto Unlock On
Passive Door Locks
Passive Arming
Voltage Sense On
Hi-Jack Start Timer 15 Sec.
Hi-Jack Feature On
or
or
or
or
or
or
or
or
or
2 Chirps
3.5 Second Door Locks
Auto Lock Off
Auto Unlock Off
Active Door Locks
Active Arming
Voltage Sense Off
Hi-Jack Start Timer 45 Sec
Hi-Jack Feature Off
System Response
No response
1 Chirp - LED 1 flash
Short chirp, then long chirp
1 chirp = 1 second door locks
2 chirps = 3.5 second door locks
2 chirps = auto locks off
1 chirp = auto locks on
2 chirps = auto unlock off
1 chirp = auto unlock on
2 chirp = active locks
1 chirps = passive locks
1 chirp = passive arming
2 chirps = active arming
2 chirps = voltage sense feature off
2 chirp = voltage sense feature on
2 chirp = Hi-jack start timer 45 seconds
1 chirps = Hi-jack start timer 15 seconds
1 chirp = Hi-jack feature on
2 chirps = Hi-jack feature off
Exit Program Mode
Exit Program Mode
Page 1
Model APS-25HJ
Installation Manual
Default
1 Second
Auto Lock Off
Auto Unlock Off
Active Locks
Passive Arming
Voltage Sense Off
Start Timer 45 Sec.
Hi-Jack Feature On

Advertisement

Table of Contents
loading

Summary of Contents for Audiovox Prestige APS-25HJ

  • Page 1: Programmable Features

    RF Programmable Features : Feature Selection 1 Chirp First 1 Second Door Locks Second Auto Lock On Third Auto Unlock On Fourth Passive Door Locks Fifth Passive Arming Sixth Voltage Sense On Seventh Hi-Jack Start Timer 15 Sec. Eighth Hi-Jack Feature On Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch in order to begin the passive arming sequence.
  • Page 2 INSTALLATION OF MAJOR COMPONENTS Control Module : Select a mounting location inside the passenger compartment ( up behind the dash ), and secure using the two screws provided. The control module can also be secured in place using cable ties. Do not mount the control module in the engine compartment, as it is not waterproof.
  • Page 3: Shock Sensor

    Shock Sensor : Select a solid mounting surface for the shock sensor on the firewall inside the passenger compartment, and mount the sensor using the two screws provided. The shock sensor can also be secured to any fixed brace behind the dash using tie straps. Whichever mounting method is selected, make certain that the sensitivity adjustment is accessible for use later in the installation.
  • Page 4 Audiovox recommends redundant test- ing of your connections to the vehicle concerning this circuit as a poor connection will prevent the vehicle from starting.
  • Page 5: Completing The Installation

    Door Lock Control Circuits In these applications, the AS 9159 Door Lock Interface ( or equivalent 30 A automotive relays ) must be used. Refer to the AUDIOVOX Door Lock Wiring Supplement for proper connection to these types of circuits.
  • Page 6 Optional Relay Required Audiovox Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-5265A Page 6...
  • Page 7 Funciones RF programables: Selección de función 1 chirrido Trabado de puertas de 1 Primera segundo Trabado automático “on” Segunda Destrabado automático “on” Tercera Trabado pasivo de puertas Cuarta Activación pasiva Quinta Detección de voltaje “on” Sexta Temporizador inicio antirrobo Séptima 15 segundos Función antirrobo “on”...
  • Page 8 INSTALACIÓN DE LOS COMPONENTES PRINCIPALES Módulo de control: Elija un lugar de montaje adentro del compartimiento del pasajero (arriba y detrás del tablero de instrumentos) y fije con los dos tornillos provistos. No instale el módulo en el compartimiento del motor dado que no es impermeable. Se debe evitar colocar la unidad directamente encima de componentes electrónicos instalados en fábrica.
  • Page 9: Cableado Del Sistema

    Conexiones de cableado del arnés de alimentación principal: Cable rojo con fusible: FUENTE CONSTANTE DE BATERÍA DE +12 VCC Este cable alimenta el módulo de control y controla la sensibilidad del circuito de detección de voltaje que detecta el encendido o apagado de una luz interior cuando se abre una puerta. Este cable detectará también la conmutación de las luces de estacionamiento o luces bajas y, en muchos casos, disparará...
  • Page 10 Audiovox no recomienda usar el cable anaranjado para interrumpir nada más que el circuito de arranque del vehículo.
  • Page 11: Finalización De La Instalación

    En estas aplicaciones, debe usarse la Interfaz para trabar las puertas AS 9159 (o relés equivalentes de 30A para automóviles). Consulte el Suplemento de cableado de trabas de puertas de AUDIOVOX para obtener información sobre la conexión adecuada de estos tipos de circuitos.
  • Page 12 Rojo Negro Conectar a tierra del chasis Interruptor del Al contacto de +12 voltios capó o baúl conmutado Audiovox Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 Véase Rojo APS-25HJ Gris Blanco Rojo con blanco Azul oscuro Negro y blanco Negro...

Table of Contents