Audiovox XRO9100 Owner's Manual page 18

Alert Alarm Timer
is an Alarm Clock that allows you to set an Hour & Minute
that you want to be reminded of something. Setting just like an alarm clock this
timer will sound when the correct time is reached. Move the side switch down 3
times, press the unlock (2) button to access, select the hour, minutes and AM or
PM as in the clock setting above, once your selection is made, lock the setting
by pressing the Start/Trunk button (3). Note, the
OLED screen while the timer is set. When the set time is reached, a beep tone
will be heard.
Count Down Timer will count down any setting of up to 11 hours and 29
minutes. Setting Hours and Minutes,,this timer will count down than sound and
alert tone when the timer expires. Move the side switch down 3 times press the
Start/Trunk button to access. Select hours by moving the side switch up or
down, press the Lock (1) button to move to the minute. Use the side switch up
or down to select the minutes, than press the Start/Trunk button to lock your
setting The Icon will appear on the OLED confirming your setting. You will
hear 3 beep tones once the count down timer expires.
Pressing the side switch in 2 or 3 times will bring up the timer
display screen (shown) allowing you to cancel the timer
anytime before the count down expires.
Transmitter Selection allows you to name the transmitter that
can function for a particular vehicle. In other words, this
transmitter will control up to 4 vehicles that have similar Audiovox Alarm Sys-
tems installed. TX1 is used for your car, TX2, can be for Lou's car, TX3 may be
for Maria's car & TX 4 can be for Jesse's car,,,you can select and name in each
case the TX1, TX2, TX3, or TX4 to make it easier to remember who's vehicle
each of the selections are programmed to.
To set TX1 for your car, press the side switch 4 times, press the Lock (1) button
than press the Lock (1) button to move to the next position, move the side
switch to select the second letter or number, etc... up to 12 characters. Once all
characters have been selected, press the Start/Trunk (3) button to lock in your
setting. Repeat for each TX you wish to name.
icon will be displayed on the
Page 18
to access TX1, than
move the side
switch up for
letters, or down to
select numbers
128-8261
18 of 24