Audiovox XRO9100 Owner's Manual page 22

Here you can press and hold the lock & start buttons simultaneously, for
controlling the unlock function of the second vehicle.
5) Press and release the program pushbutton switch once to advance to
channel 3, start.
Here you can press and hold the start & option buttons simultaneously, for
controlling the start function of the second vehicle etc....
DELETING TRANSMITTERS FROM YOUR SYSTEM:
It may be necessary to delete a lost transmitter or to re-prioritize a transmitter
that is programmed to your system. To remove a transmitter that has been
programmed in your system:
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold any transmitter button that has not been programmed into
channel 1 until you hear a chirp, then release and immediately press the
same button a second time until you hear a long chirp followed by a short
chirp. This action erases the transmitter.
If the transmitter you wish to erase has been lost or stolen then following the
information below will successfully remove the transmitter.
NOTE: For this procedure, you must have all transmitters you wish to remain
programmed in your system available.
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold the lock button of each transmitter you wish to operate the
lock function of your unit making sure you occupy all 4 transmitter slots. In
other words, you have three transmitters you wish to remain programmed.
Press and hold the lock button of transmitter one until a long chirp is heard,
then press and hold the lock button of transmitter two, then press and hold
the lock button of transmitter three, followed by pressing and holding the
lock button of transmitter one again. This action fills all 4 receiver slots.
3) Advance to receiver channel 2 by pressing the pushbutton switch one time.
4) Press and hold the unlock button of each transmitter you wish to operate
the unlock function of your vehicle, again making sure all 4 transmitter slots
are filled.
4) Advance to receiver channel 3 by pressing the pushbutton switch one time.
5) Press and hold the unlock button of each transmitter you wish to operate
the start function of your vehicle, again making sure all 4 transmitter slots
are filled.
If you are uncomfortable about the programming of additional transmitters as
outlined in the processes above please contact your installation center or call
the technical service number listed on the back of the transmitter for help
Page 22
.
128-8261
22 of 24