Table of Contents
Advertisement
B
EFORE
Displaying Navigation Screen
The DVD-ROM map data disc must be inserted into the Navigation system before starting to use
the Navigation system. This section describes how to display the initial Navigation screens.
1
Start the vehicle's engine by turning the ignition key
to the ON position. The opening screen appears on
the monitor display.
If a CVA-1000/CVA-1005 type system control monitor is
used, you may not see this screen.
2
The display shows "Please insert DVD-ROM/ map
data disk." Insert the DVD-ROM disc into the NVE-
N851A Series Navigation System. (For instructions on
inserting and removing the DVD-ROM disc, refer to
the NVE-N851A Series Hardware Manual.)
3
A disclaimer screen appears. Please read this
important information. Press the ENTER button on the
remote control if you accept this statement.
4
Once the ENTER button on the remote control is
pressed, the map screen will appear on the display.
The vehicle's present location is indicated. If the
vehicle's present location is incorrect, drive the vehicle
several miles in an area with an open view to sky. This
will correctly synchronize the navigation system.
The calculation process of the present vehicle's position
using GPS signals takes approximately 10 minutes after
turning on the Navigation system. During this period, the
present vehicle's position indicator does not move even if
the vehicle moves.
6
U
T
SING
HE
S
YSTEM
Advertisement
Table of Contents
