Changing The Digital Output Setting - Alpine DVA-5200 Owner's Manual

SET UP

Changing the digital output setting

ENTER
32
Changing the digital
output setting
Use the following procedure to set the
audio signal output from the DVA-5200.
Select "DIGITAL OUT" under
"Changing the default settings
(SET UP)" on page 26.
Use the " 8 " or " 9 " key to make
the selection, then press "EN-
SET UP
TER".
RETURN
AUTO
The digital output is switched automatically
according to the type of audio signals being
played.
Be sure to select "AUTO" when you want to
connect a digital audio processor and play
Dolby Digital audio. "AUTO" is selected upon
shipment from the factory.
LPCM
The audio signals recorded on the disc are
converted into 48 kHz/16 bit (for DVDs) or 44.1
kHz (for video CDs and CDs) linear PCM audio
signals for output.
Note: Press "RETURN" to return to the previous
screen.
Press "SET UP".
The set up are stored and the
set up mode is canceled.
or
ENTER
SET UP