Changing The Digital Output Setting - Alpine DVA-5205 Owner's Manual

SET UP

Changing the digital output setting

ENT
32
Changing the digital
output setting
Use the following procedure to set the
audio signal output from the DVA-5205.
Select "DIGITAL OUT" under
"Changing the default settings
(SET UP)" on page 24.
Use the "Joystick" to make the
selection, then press "ENT".
ENT
AUTO
The digital output is switched automatically
according to the type of audio signals being
played.
Be sure to select "AUTO" when you want to
connect a digital audio processor and play
Dolby Digital audio. "AUTO" is selected upon
shipment from the factory.
LPCM
The audio signals recorded on the disc are
converted into 48 kHz/16 bit (for DVDs) or 44.1
kHz (for video CDs and CDs) linear PCM audio
signals for output.
ENT