Fmadm Config Command; Using The Fmstat Command - Fujitsu SPARC Enterprise M5000 Service Manual

If fmadm faulty occurs, the FMA resource cache on the OS side can be cleared
without problems; the data in it need not match the hardware failure information
retained on the XSCF side.
# fmadm repair
STATE RESOURCE / UUID
-------- --------------------------------------------------------
degraded dev:////pci@1e,600000
2.6.3.2

fmadm config Command

The fmadm config command output shows you the version numbers of the
diagnosis engines in use by your server, as well as their current state. You can check
these versions against information on the My Oracle Support web site to determine if
you are running the latest diagnostic engines, as shown in the following example.
XSCF> fmadm config
MODULE
eft
event-transport
faultevent-post
fmd-self-diagnosis
iox_agent
reagent
sysevent-transport
syslog-msgs
XSCF>
2.6.4

Using the fmstat Command

The fmstat command can report statistics associated with the Oracle Solaris fault
manager. The fmstat command shows information about DE performance. In the
example below, the fmd-self-diagnosis DE (also seen in the console output) has
received an event which it accepted. A case is "opened" for that event and a
diagnosis is performed to "solve" the cause for the failure. See the following
example.
2-24 SPARC Enterprise M4000/M5000 Servers Service Manual • December 2010
0ee65618-2218-4997-c0dc-b5c410ed8ec2
VERSION STATUS
1.16 active
2.0 active
1.0 active
1.0 active
1.0 active
1.1 active
1.0 active
1.0 active
DESCRIPTION
eft diagnosis engine
Event Transport Module
Gate Reaction Agent for errhandd
Fault Manager Self-Diagnosis
IO Box Recovery Agent
Reissue Agent
SysEvent Transport Agent
Syslog Messaging Agent