Upgrading A Sparc64 Vi Cpu Module To Sparc64 Vii/Sparc64 Vii+ On An Existing Domain - Fujitsu SPARC Enterprise M5000 Service Manual

12.2.3 Upgrading a SPARC64 VI CPU Module to
SPARC64 VII/SPARC64 VII+ on an Existing
Domain
This procedure must be proceeded by
VII+ Processors to an Existing Domain" on page
that procedure please do so before continuing.
1. Replace the SPARC64 VI CPU module with the SPARC64 VII/SPARC64 VII+
CPU module.
For instructions, refer to Chapter 12, "CPU Module Replacement," in the SPARC
Enterprise M4000/M5000 Servers Service Manual. Note that this procedure involves
powering down the entire server.
Caution – After installing the CPU module, you must reconnect the power cable to
the power supply.
2. Log in to the XSCF again, using an account with platadm or fieldeng
privileges.
3. Perform an initial diagnosis of the newly installed CPU module.
XSCF> testsb 01
The following example shows a test after adding PSB#01 to a SPARC Enterprise
M5000 server:
XSCF> testsb 01
Initial diagnosis is about to start. Continue? [y|n] : y
Initial diagnosis is executing.
Initial diagnosis has completed.
XSB Test Fault
---- ------- --------
01 Passed Normal
4. Confirm that the installed CPU module is recognized by the server and that the
error indicator asterisk (*) is not displayed.
XSCF> showhardconf -M
"Preparing to Add SPARC64 VII/SPARC64
12-11. If you have not completed
Chapter 12 CPU Module Replacement 12-15