Installing The Cd-Rw/Dvd-Rw Drive Backplane Of The M4000 Server; Securing The Server - Fujitsu SPARC Enterprise M5000 Service Manual

3. Loosen the captive screw that holds the rear of the CD-RW/DVD-RW Drive
Backplane in place.
The CD-RW/DVD-RW Drive Backplane is a unit that the CD-RW/DVD-RW Drive
Unit slides into.
4. Remove the CD-RW/DVD-RW Drive Backplane and place it on the ESD mat.
6.2.8 Installing the CD-RW/DVD-RW Drive Backplane
of the M4000 Server
1. Place the CD-RW/DVD-RW Drive Backplane onto the guide pin.
2. Tighten the captive screw that holds the rear of the CD-RW/DVD-RW Drive
Backplane in place.
3. Secure the power and serial cables to the rear of the CD-RW/DVD-RW Drive
Backplane.
Caution – Do not force the CD-RW/DVD-RW Drive Unit into a slot. Doing so can
cause damage to the drive and server.
4. Install the CD-RW/DVD-RW Drive Unit.
See
6.2.9

Securing the Server

1. Install the fan cover.
This step includes replacing the fan cover, installing the 60-mm fan units, sliding
the server in to the equipment rack and restoring the rack antitilt features to their
original position. See
2. Power the server on.
This step includes reconnecting power cables, and turning the keyswitch to the
Locked position. See
page
Section 6.2.4, "Installing the CD-RW/DVD-RW Drive Unit" on page
Section 5.3.2, "Replacing the Fan Cover" on page
Section 4.4.2, "Powering the Server On Using Software" on
4-13.
Chapter 6 Storage Devices Replacement
6-17.
5-10.
6-19