Backplane Unit Replacement; Accessing The M4000 Server Backplane Unit - Fujitsu SPARC Enterprise M5000 Service Manual

FIGURE 14-2
FIGURE 14-2
14.1.1

Accessing the M4000 Server Backplane Unit

Caution – There is an electrical hazard if the power cords are not disconnected. All
power cords must be disconnected to completely remove power from the server.
1. Power off the server.
This step includes turning the key switch to the Service position, confirming that
the POWER LED is off, and disconnecting power cables. See
"Powering the Server Off Using Software" on page
shows the backplane unit location on the M5000 server.
M5000 Server Backplane Unit Location
Section 4.4.1,
4-12.
Chapter 14

Backplane Unit Replacement

14-3