Securing The Server - Fujitsu SPARC Enterprise M5000 Service Manual

3. Connect the power and serial cables to the rear of the CD-RW/DVD-RW Drive
Backplane.
Caution – Do not force the CD-RW/DVD-RW Drive Unit into a slot. Doing so can
cause damage to the drive and server.
4. Install the CD-RW/DVD-RW Drive Unit.
See
6.2.13

Securing the Server

Caution – The motherboard unit is heavy. Two people are recommended to lift the
unit.
1. Install the motherboard unit.
This step includes installing the motherboard cradle, securing the busbar screws,
and installing the CPU modules and filler panels See
M5000 Server Motherboard Unit" on page
2. Install the top cover.
This step includes sliding the server in to the equipment rack and restoring the
antitilt features to their original position. See
Cover" on page
3. Power the server on.
This step includes reconnecting power cables, verifying the state of the LEDs, and
turning the keyswitch to the Locked position. See
Server On Using Software" on page
Note – If the Oracle Solaris automatic booting is set, use the sendbreak -d
domain_id command after the display console banner is displayed but before the
system starts booting the operating system to get the ok prompt.
4. Confirm the hardware.
This step includes running programs to be certain all components are mounted
again and then booting the operating system.
Refer to
information.
6-22 SPARC Enterprise M4000/M5000 Servers Service Manual • December 2010
Section 6.2.4, "Installing the CD-RW/DVD-RW Drive Unit" on page
5-8.
Section 4.3.2, "Verifying Hardware Operation" on page 4-9
Section 13.1.7, "Installing the
13-10.
Section 5.2.2, "Replacing the Top
Section 4.4.2, "Powering the
4-13.
6-17.
for more