To assign volume, gain, or the input level to the reverb or
delay effect, proceed as follows.
• Volume: Use the VOLUME knob, and then hold down the
EXPRESSION switch for about two seconds.
• Gain: Press the AMPS bank select switch or STAND ALONE
PEDALS switch, use the GAIN knob, and then hold down the
EXPRESSION switch for about two seconds.
• Pedal 1: Use the PEDAL 1 knob, and then hold down the
EXPRESSION switch for about two seconds.
• Input level to the reverb effect: Use the REVERB knob,
and then hold down the EXPRESSION switch for about
two seconds.
• Input level to the delay effect: Use the DELAY knob, and
then hold down the EXPRESSION switch for about two
seconds.
To clear the expression pedal to an unassigned state
Hold down the EXPRESSION switch and press the EXIT/
TUNE switch. The expression pedal assignment will be
cleared, and the EXPRESSION PEDAL LED will go dark.
The expression pedal will also revert to an unassigned state if
you switch to a different effect.
However in the following cases, the setting will be main‐
tained and the assignment will not change.
• After the GAIN parameter of the amp model or standalone
pedal type was assigned to the expression pedal, you
changed the amp model or standalone pedal type.
32
Expression pedal minimum and
maximum values
The minimum value is when the expression pedal is fully
returned toward yourself; the maximum value is when the
expression pedal is fully advanced away from yourself.
When you assign a parameter or volume to the expression
pedal, the minimum and maximum values of the expression
pedal will be set automatically.
Adjusting the minimum and maximum parameter values
When you assign an effect parameter to the expression pedal,
the minimum and maximum values appropriate for that
parameter will be assigned as the minimum and maximum
values of the expression pedal. If you assign the PITCH
parameter of the PITCH, the minimum value will be "0" (no
pitch shift) and the maximum value will be the current value.
You can adjust the minimum and maximum values as fol‐
lows.
NOTE: If the reverb, delay effect input level is assigned to the
expression pedal, the minimum and maximum values
will be set automatically, and cannot be changed.
1. Press the EXPRESSION switch.
The Quick Assign LED will blink.
If an effect is assigned to the expression pedal
The on/off switch LED of the assigned effect will blink,
and the bank/value display will indicate "
".