b. TUNER LED
These lights are used for tuning (p. 29, "Tuner").
When you're using the tuner, the LEDs will indicate the tun‐
ing status.
c. Stereo speakers
You can listen to the sound output from the built‐in stereo
speakers. To adjust the volume level, use the SPEAKER
LEVEL control on the rear panel (p. 8).
NOTE: The speakers will be muted when a cable is connected
to the OUTPUT/PHONES jack.
NOTE: Some programs (especially those with an emphasized
low range) may cause the sound from the speakers to
be distorted or noisy. In such a case, adjust the volume
level using the SPEAKER LEVEL control.
4. Pedal 1 section
Here you can adjust the settings for the
pedal 1 effects.
For details on each effect, refer to "Pedal
1" (p. 23)
a. PEDAL 1 ON/OFF switch and LED
This turns the pedal 1 effect on/off.
The LED will be lit if the pedal 1 effect is on.
b. PEDAL 1 knob
Rotating this knob enables you to select the pedal 1 effect
type and adjusts the effect parameters assigned to each effect.
If the pedal 1 effect is turned off, rotating this selector will
turn the pedal 1 effect on.
5. Pedal 2 section
Here you can adjust the settings for the pedal 2 effects.
For details on each effect, refer to "Pedal 2" (p. 24).
a. PEDAL 2 ON/OFF switch
and LED
This turns the pedal 2 effect
on/off. The LED will be lit if
the pedal 2 effect is on.
b. PEDAL 2 selector
This selects the pedal 2 type.
If the pedal 2 effect is turned
off, turning this selector will
turn the pedal 2 effect on.
c. EDIT knob
This adjusts the parameters of each effect.
6. Modulation section
Here you can adjust the set‐
tings for the modulation effect.
For details on each effect, refer
to "Modulation" (p. 25).
a. MODULATION ON/OFF switch
a
b
and LED
This switch turns the modula‐
tion effect on/off.
The LED will be lit if the effect is on.
a
b
c
a
c d
b
5