Vox Tonelab EX Owner's Manual page 17

Adjusting the high-frequency tone (Presence)
Hold down the CABINET on/off switch for about one sec‐
ond to enter OPTION parameter setting mode, and then
turn the TREBLE control.
5. Select and adjust the effects of other sections.
For example if you want to add TAPE ECHO, turn the
DELAY selector to select TAPE ECHO.
If the selector is already positioned at TAPE ECHO, turn it
to some other delay type and then back to re‐select TAPE
ECHO.
Use the TAP switch or EDIT knob to set the delay time, de‐
lay level (the mix amount of delay sound), and feedback.
To set the delay time
Press the TAP switch twice (the time will be set to the in‐
terval that was used to press the switch).
To adjust the delay level or feedback
Delay level: Turn the EDIT knob.
Feedback: Hold down the TAP switch and turn the EDIT
knob.
For details on the effect types, refer to "About the amp
models, cabinet models, and effect types" (p. 15).
HINT: If you've selected a pedal effect, it might be easier to
make adjustments if other effects are not being ap‐
plied. If so, adjust the pedal effect after you've speci‐
fied the amp model and cabinet model, but before
you adjust settings for other effects.
6. When you've come up with a sound that you like, save it
as a program.
For details, refer to "Saving a program" (p. 15).
NOTE: If you switch to a different program or turn off the
power before saving, the changes you've made will
be discarded, and the settings will revert to their
original state.
Parameter original value indication
This is a way for you to check the original value of a parame‐
ter; i.e., the value that was saved in the preset program or
user program.
When youʹre using a knob to edit the value of a parameter,
the decimal point in the lower left of the bank/value display
LED is lit‐up momentarily when the edited value matches the
original value.
HINT: You can take advantage of this original value indication
to find out the actual settings of a program that you
like.
NOTE: The settings of the rear panel LEVEL knob, SPEAKER
LEVEL, Total Equalizer, and AMP/LINE switch set‐
tings are not saved, and will not be shown by the orig‐
inal value indication. Nor will the original value of the
SPEED parameter or TIME parameter be shown when
you use the TAP switch to set the SPEED parameter or
TIME parameter.
13