Uart (X4); Can Interface (X2, X3) - Fujitsu FLASH-CAN-100 User Manual

7.4 UART (X4)

One 9-pin D-Sub female connectors are used
for the serial interface (UART).
TXD is the transmit output, RXD is the receive input.
The DTR signal can be used to generate a reset.
Please use 1:1 cable for PC-connection.

7.5 CAN Interface (X2, X3)

Two 9-pin D-Sub male connector
are used for the CAN interface.
Adjust both potentiometers (P1, P2) clockwise
to their end position.
(Check that Pin 8 of U4 and Pin 8 of U5 are grounded.)
UG-900001-32
Change even page title here
Chapter 7 Connectors
Connector X4:
Connector X2, X3:
- 16 - © Fujitsu Microelectronics Europe GmbH
GND DTR RxD TxD
5
9
CTS RTS DSR
GND
5
9
CANH
1
6
CANL
1
6