Connectors; Power Connector (X13); Edge Connector (X4, X5) - Fujitsu SK-91465X-100PMC User Manual

SK-91465X-100PMC User Guide
Chapter 5 Connectors

5 Connectors

5.1 Power Connector (X13)

The following figure shows the power connection jack of the starter kit. This connector is
used to connect an external unregulated DC power supply voltage (12V DC max. 2600mA).
Shield is connected to positive voltage supply (+)
Centre is connected to ground (GND)
Figure 5-1: Power Connector

5.2 Edge connector (X4, X5)

All pins (except oscillator Pins) of the microcontroller are directly connected to X4 and X5 as
follows:
Connector MCU Pins
X4 (1 – 50) 1 – 50
X25 (51 – 100) 51 – 100
Table 5-1: MCU Pin Connectors
The odd pin numbers are located on the one side and the even pin numbers are located on
the other side of the connector.
© Fujitsu Microelectronics Europe GmbH - 27 - UG-910056-11