Fujitsu FLASH-CAN-100 User Manual page 11

7. Select the appropriate UART interface for the microcontroller you are using by setting
jumper JP7-JP10.
8. Please use 1:1 cable for PC-connection.
Notes:
< Pixx on the silk plot stands for Pinxx, i.e. the pin number.
e.g. for the MB90F598, set JP10 and JP9 to connect Pin 1 and 2 in order use UART 1
< MB90425, MB90470, MB90480 and MB90580 series are not supported by jumpers.
Please make handwired connections for these controllers.
Target Series
MB90425
MB90435
MB90440
MB90470
MB90480
MB90540
MB90545
MB90550
MB90580
MB90590
MB90595
Table 2: MCU pin-number used, for the asynchronous boot-loader software
© Fujitsu Microelectronics Europe GmbH
Change odd page title here
Chapter 5 Configuration of the Evaluation-Board
Asynch.
SIN / Jumper
Com.
handwire Pin 88 – JP10.2
UART1
UART1 Pin 21 (JP10:1-2)
UART1 Pin 21 (JP10:1-2)
handwire Pin 27 – JP10.2
UART0
handwire Pin 27 – JP10.2
UART0
UART1 Pin 21 (JP10:1-2)
UART1 Pin 21 (JP10:1-2)
UART0 Pin 20 (JP8:1-2)
handwire Pin 18 – JP10.2
UART0
UART0 Pin 16 (JP8:2-3)
UART1 Pin 21 (JP10:1-2)
(Not supported by Jumper JP7 - JP10)
(Not supported by Jumper JP7 - JP10)
see chapter 6.1 !
(Not supported by Jumper JP7 - JP10)
see chapter 6.1 !
(Not supported by Jumper JP7 - JP10)
- 11 -
SOT / Jumper
handwire Pin 89 – JP9.2
Pin 24 (JP9:1-2)
Pin 24 (JP9:1-2)
handwire Pin 28 – JP9.2
handwire Pin 28 – JP9.2
Pin 24 (JP9:1-2)
Pin 24 (JP9:1-2)
Pin 19 (JP7:1-2)
handwire Pin 19 – JP9.2
Pin 14 (JP7:2-3)
Pin 24 (JP9:1-2)
UG-900001-32