Revision History - Fujitsu FLASH-CAN-100 User Manual

Revision History

Date Version Issue
07.12.98 V1.0
07.12.98 V1.0
07.12.98 V1.2
07.12.98 V1.2
07.12.98 V1.2
07.12.98 V1.2
07.12.98 V1.2
07.12.98 V1.2
07.12.98 V1.2
13.01.99 V1.1
01.02.99 V1.2
03.02.99 V1.2
03.02.99 V1.2
12.02.99 V1.2a
17.05.99 V2.0
17.05.99 V2.0
17.05.99 V2.0
17.05.99 V2.0
26.05.99 V2.0
26.05.99 V2.0
26.05.99 V2.0
16.07.99
16.07.99
21.07.99 V2.1
05.08.99 V2.1
UG-900001-32
Change even page title here
Revision History
P14,P16 connected to JP7, JP8 (RS232 interface for MB90F594A)
must be changed
Jumper on JP10, JP9 Pin2+3 must be changed to Pin 1+2
to connect to UART1
Silk-Plot: Version number must be added.
Silk-Plot: SIT/SOT is not correct. Must be changed.
Silk-Plot: CAN100BOARD is not correct.
Silk-Plot: In RS232 Jumper area - naming of pins must be changed
from Pxx to Pinxx.
Silk-Plot: In CAN Jumper area - naming of pins must be changed
from Pxx to Pinxx.
JP13 was not placed on the board.
Allow connection of X4 (RS232 Sub-D-9 female) Pin 7+8
on the DIP switch S3 Pin 5.
Page 6 of this manual - item 6.4 not X3 – must be X4
Fig. 2 – Schematic of Flash-CAN-100P-M06 misprint: External voltage
supply plug must have Gnd on the inside and +12V on the outside.
Disclaimer added to manual
Manual revised to include information about Flash programming
software tools, which in now available in this package
MB90580 series added – Can be used with this board also (only QFP
100 package!)
Silk Plot changed to new Name: FLASH-CAN2-100P-M06
New Socket Adapter for MCU used (NQPACK100RB)
FLASH-CAN2-100P-M06 added in documentation
Revised Silk plot in documentation
Replace Pxx by Pixx in Chapter 5
Chapter 6 – DIP-switch setting revised for asynchronous loader
software
Table1 + 2 added in this document
X0+X1 are not available on socket pin
V2.0: Connection of new socket adapter must be watched carefully.
MCU might not have good contact
Schematic of board added to this manual
Attached Floppy modified to incl. Softune Worbench Projects
see \readme.txt – Revision V1.2
- 2 - © Fujitsu Microelectronics Europe GmbH