Table of Contents
Advertisement
5.5 MCU Pin Headers (X4-X11)
All MCU pins besides the clock pins (83, 84, 171, 172), the C-pins (20, 73, 124) and the
DEBUGIF pin (103) are connected to the headers X4 to X11 as the following table shows.
Connector
X4 (1 - 26)
X5 (1 - 26)
X6 (1 - 26)
X7 (1 - 26)
5.6 Video Jack (X12)
The video jack is a standard RCA socket for composite video signal input. The centre of the
connector X12 is connected to JP15 which can (see section 4.12) direct this signal to the
MCU pin VIN (pin 205). The outer shield is connected to GND. The following picture shows
the connections of X12.
5.7 CAN 'A' connector (X13)
The connector of CAN 'A' is a male 9-pin D-Sub connector. CANH is connected to pin 7 and
CANL is connected to pin 2. Pin 3 is connected to GND.
X13 pin no.
1
2
3
4
5
UG-910097-11
Chapter 5 Connectors
J4 pin no.
1
2
3
Table 17. Video Input Header J4: Pin Description
MCU Pins
1 – 26
27 – 52
53 – 78
79 – 104
Table 18. MCU pin Headers, X4-X11
Shield: Ground (GND)
Centre: Video Signal
Figure 4: Video Jack X12
Signal
n/c
CANL
GND
n/c
n/c
- 22 -
Description
5V
Video Input Signal
GND
Connector
X8 (1 - 26)
X9 (1 - 26)
X10 (1 - 26)
X11 (1 - 26)
Figure 5: CAN 'A' connector
© Fujitsu Semiconductor Europe GmbH
MCU Pins
105 – 130
131 – 156
157 – 182
183 – 208
Advertisement
Table of Contents
