Enable Rtls On Controller; Troubleshooting Rtls - Dell PowerConnect W-Airwave Manual

Enable RTLS on Controller

NOTE: RTLS can only be enabled on the master controller and it will automatically propagate to all local controllers.
SSH into master controller, enter "enable" mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # ap system-profile <PROFILE USED BY THIN APs>
(Controller-Name) (AP system profile default) # rtls-server ip-addr <IP OF AMP SERVER> port 5050
key <SNMPv3 MMS PASSWORD CONFIGURED ON CONTROLLER>
(Controller-Name) (AP system profile default) # write mem
To validate exit configuration mode:
(Controller-Name) # show ap monitor debug status ip-addr <IP ADDRESS OF ANY THIN ACCESS POINTS>
...
RTLS configuration
-------------------
Type
----
MMS
Aeroscout N/A
RTLS

Troubleshooting RTLS

Ensure the RTLS service is running on your AMP server. SSH into your AMP server.
[root@AMPServer]# daemons | grep RTLS
root
or
Navigate to System > Status and look for the RTLS service, as shown in
Figure 28 RTLS System Status
Check the RTLS log file to ensure Tag chirps are making it to the AMP server. SSH into your AMP server.
[root@AMPServer]# logs
[root@AMPServer]# tail rtls
payload:
00147aaf01000020001a1ec02b3200000001000000137aae0100000c001a1ec02b320000001a1e82b32259
0006ddff02
1224534900.588245 - got 96 bytes from 10.51.1.39 on port 5050
Mon Oct 20 13:35:00 2008: 1224534900.588338 - got 96 bytes from 10.51.1.39 on port 5050
payload:
0014c9c90100003c001a1ec050780000000200000013c9c70100000c001a1ec050780000000d54a7a28054
0001ddff020013c9c80100000c001a1ec050780000000cdb8ae9a9000006c4ff02
1224534900.588245 - got 96 bytes from 10.51.1.39 on port 5050
Mon Oct 20 13:35:00 2008: 1224534900.588338 - got 96 bytes from 10.51.1.39 on port 5050
payload:
0014c9c90100003c001a1ec050780000000200000013c9c70100000c001a1ec050780000000d54a7a28054
0001ddff020013c9c80100000c001a1ec050780000000cdb8ae9a9000006c4ff02
Dell PowerConnect W-AirWave | Best Practices Guide
Server IP Port Frequency Active
--------- ---- --------- ------
10.51.2.45 5070 120
N/A N/A
10.51.2.45 5050 60
17859 12809 0 10:35 ?
*
00:00:00 Daemon::RTLS
Increasing Location Accuracy | 47