Wms Offload Utilizing Amp; Define Amp As Trap Host Using Arubaos Cli - Dell PowerConnect W-Airwave Manual

audit these setting (display mismatches) and you will need to apply to the controller by hand. See
"CLI ArubaOS & AMP Commands" on page 37
These are the commands pushed by AMP while enabling WMS Offload (do not enter these commands):
configure terminal
no mobility-manager <Active WMS IP Address>
wms
general collect-stats enable
stats-update-interval 120
show wms general
write mem

WMS Offload Utilizing AMP

To offload WMS on the Dell PowerConnect W-Series controllers using AMP:
1. In AMP Setup > General, locate the Device Configuration section and enable or disable Allow WMS
Offload Configuration in Monitor-Only Mode.
2. Select Save and Apply. This will push a set of commands via SSH to all Dell PowerConnect W Master
Controllers. If the controller does not have an SNMPv3 user that matches the AMP database it will
automatically create a new SNMPv3 user. AMP must have read/write access to the controllers in order to push
these commands
3. Navigate to Groups > Basic and locate the Dell PowerConnect W section.
4. Set the Offload WMS Database field to Yes, as shown previously in
NOTE: This process will not reboot your controllers. See
utilize ArubaOS CLI to enable stats or WMS Offload.
CAUTION: The SNMPv3 user's Auth Password and Privacy Password must be the same.
Do not enter these commands; these are pushed by AMP while enabling WMS Offload.
configure terminal
mobility-manager <AMP IP> user <AMP SNMPv3 User Name> <AMP Auth/Priv PW>
stats-update-interval 120
write mem
NOTE: AMP will configure SNMPv2 traps with the mobile manager command.

Define AMP as Trap Host using ArubaOS CLI

To ensure the AMP server is defined a trap host, SSH into each controller (Master and Local), enter "enable"
mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
22 | AMP and Dell PowerConnect W-Series Integration Strategies
for detailed instructions.
Figure
Appendix A, "CLI ArubaOS & AMP Commands" on
Dell PowerConnect W-AirWave | Version 7.3
Appendix A,
9.
page 37on how to