Arm Traps; Ensuring That Ids & Auth Traps Display In Amp Using Cli - Dell PowerConnect W-Airwave Manual

wlsxFrameReceiveErrorRateExceeded

wlsxFrameFragmentationRateExceeded

wlsxFrameBandWidthRateExceeded

wlsxFrameLowSpeedRateExceeded

wlsxFrameNonUnicastRateExceeded

wlsxChannelRateAnomaly

wlsxNodeRateAnomalyAP

wlsxNodeRateAnomalySta

wlsxEAPRateAnomaly

wlsxSignalAnomaly

wlsxSequenceNumberAnomalyAP

wlsxSequenceNumberAnomalySta

wlsxApFloodAttack

wlsxInvalidMacOUIAP

wlsxInvalidMacOUISta

wlsxStaRepeatWEPIVViolation

wlsxStaWeakWEPIVViolation

wlsxStaAssociatedToUnsecureAP

wlsxStaUnAssociatedFromUnsecureAP

wlsxAPImpersonation

wlsxDisconnectStationAttackAP

wlsxDisconnectStationAttackSta


ARM Traps

AP Power Change

AP Mode Change

AP Channel Change

Ensuring That IDS & Auth Traps Display in AMP Using CLI
Validate your ArubaOS configuration by exiting the configure terminal mode and issue the following command:
(Controller-Name) # show snmp trap-list
If any of the traps below don't show as enabled enter
command:
(Controller-Name) (config) # snmp-server trap enable <TRAPS FROM LIST ABOVE>
(Controller-Name) (config) # write mem
NOTE: See
directly into the ArubaOS CLI.
Ensure the source IP of the traps match the IP that AMP utilizes to manage the controller, as shown in
Navigate to APs/Devices > Monitor to validate the IP address in the Device Info section.
24 | AMP and Dell PowerConnect W-Series Integration Strategies
Appendix A, "CLI ArubaOS & AMP Commands" on page 37
mode and issue the following
configure terminal
for the full command that can be copied and pasted
Dell PowerConnect W-AirWave | Version 7.3
Figure 10.