Adding An Idf - Dell PowerConnect W-Airwave User Manual

Figure 12 Adding a New Location Probability Region
5. Optionally, you can save the location region as the exterior walls. 100% attenuation can be selected to force
VisualRF to only place devices inside of the selected region. No device will ever be placed outside of the
probability region when 100% attenuation is selected. 100% attenuation is only recommended for tall
buildings where it is extremely unlikely that any user is located outside of the building. No heat map or
attenuation grid is calculated for devices outside of the 100% attenuation region.

Adding an IDF

To add an IDF to VisualRF, follow these steps:
1. Expand the Edit widget and select the Draw Regions icon (red empty squares).
2. Outline the desired IDF region. Double-click to end the outline process.
3. Name the region, select a Region Type of IDF, and select OK.
Figure 13 Adding a new IDF Region
22 | Setting Up and Tuning VisualRF Dell PowerConnect W AirWave 7.2 | VisualRF User Guide