34
WARNING:
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1
Connect the interposer to the optical drive.
2
Align the screw holes on the optical-drive bracket with the screw holes on the optical
drive and replace the screws that secure the optical-drive bracket to the optical
drive.
3
Align the slot on the optical-drive bracket with the alignment posts on computer
base and place the optical-drive assembly in the computer base.
4
Replace the screws that secure the optical-drive assembly to the computer base.
5
Adhere the optical-drive cable to the computer base, slide the cable into the
connector on the system board, and press down on the connector latch to secure the
cable.
Postrequisites
1
Replace the I/O board. See "Replacing the I/O Board" on page 62.
2
Follow the instructions from step 2 to step 5 in Replacing the Palm Rest.
3
Replace the dispaly assembly. See "Replacing the Display Assembly" on page 48.
4
Replace the macro keyboard. See "Replacing the Macro Keyboard" on page 38.
5
Replace the keyboard. See "Replacing the Keyboard" on page 35.
6
Replace the center control cover. See "Replacing the Center Control Cover" on
page 29.
7
Replace the base cover. See "Replacing the Base Cover" on page 15.
8
Replace the battery pack. See "Replacing the Battery Pack" on page 13.
9
Follow the instructions in "After Working Inside Your Computer" on page 11.
66
|
Replacing the Optical Drive
Replacing the Optical Drive
Before working inside your computer, read the safety