Replacing The Graphics-Card Assembly; Procedure; Postrequsites - Alienware M17x R4 Owner's Manual

18
WARNING:
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.

Procedure

1 Insert the graphics card connector at a 45-degree angle into the connector on the
system board.
2 Press the other end of the graphics-card assembly down into the slot on the system
board and replace the two screws that secure the graphics-card assembly to the
system board.

Postrequsites

1 Replace the graphics-card heat sink fan. See "Replacing the Graphics-Card Heat Sink
Fan" on page 28.
2 Replace the compartment door. See "Replacing the Compartment Door" on page 15.
3 Replace the battery pack. See "Replacing the Battery Pack" on page 13.
4 Follow the instructions in "After Working Inside Your Computer" on page 11.
34
|

Replacing the Graphics-Card Assembly

Replacing the Graphics-Card
Assembly
Before working inside your computer, read the safety