Removing The Display Assembly; Prerequsites; Procedure - Alienware M17x R4 Owner's Manual

33
WARNING:
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.

Prerequsites

1 Remove the battery pack. See "Removing the Battery Pack" on page 12.
2 Remove the compartment door. See "Removing the Compartment Door" on page 14.
3 Remove the center control cover. See "Removing the Center Control Cover" on
page 41.
4 Remove the keyboard. See "Removing the Keyboard" on page 45.
5 Disconnect the antenna cables from the Mini-Card. See "Removing the Mini-Card" on
page 49.
6 Disconnect the wirelessHD card cable from the connector on the wirelessHD card.
See "Removing the WirelessHD Card" on page 53.

Procedure

1 Loosen the captive screws that secure the display cable to the system board.
2 Using the pull-tab, pull the display cable to disconnect the display cable from the
connector on the system board.
3 Disconnect the camera cable and infrared cable from the respective system board
connectors.
4 Note the routing of the display cable, camera cable, infrared cable, wirelessHD card
cable, Mini-Card antenna cables and remove the cables from the routing guides on
the palm rest assembly.
Removing the Display
Assembly
Before working inside your computer, read the safety

Removing the Display Assembly

57
|