System Board Front Panel Connectors; Typical Front Panel Connectors - Fujitsu ErgoPro m664 Series Specialist's Handbook

PC Specialist's Handbook
Recovery Mode (Force Flash Load procedure)
Recovery mode is for upgrading the BIOS or recovering BIOS data. To enable recovery mode remove
single jumper from configuration header. When this mode is enabled BIOS tries to recover or upgrade
BIOS from BIOS diskette in floppy drive.
BEEP codes indicates recovery/upgrade status:
- one beep: start of recovery/upgrade.
- two beeps: succesful recevery/upgrade.
- multiple beeps: failed recovery/upgrade.
Note: If recovery/upgrade BIOS diskette not in floppy drive BIOS runs POST test and displays message:
jumper is not properly installed.
To make changes become valid:
- Exit setup program
- Shut down computer and disconnect Main power from system unit.
- Change configuration jumper in normal mode
- Boot up the computer

System board front panel connectors

Picture 22 :Typical front panel connectors
Edition 1 - Release 1 - March 1998
Power LED
Speaker
HDD LED
Reset
27
BLACK
GREEN BLACK
BLACK
RED WHITE RED
Fujitsu default connectors are represented
with pattern and typical colours are also
indicated
POWER
SLEEP
INFRA RED
BLACK ORANGE RED
WHITE
ErgoPro m664-series
1
BLACK
Page 2-5