Bios Error Messages - Fujitsu ErgoPro m664 Series Specialist's Handbook

ErgoPro m664-series

BIOS Error Messages

List of Error messages:
Error Message
Diskette drive A error or Diskette drive
B error
Extended RAM Failed at offset: nnnn
Failing Bits: nnnn
Fixed Disk 0 Failure or Fixed Disk 1
Failure or Fixed Disk Controller
Failure
Incorrect Drive A type - run SETUP
Invalid NVRAM media type
Keyboard controller error
Keyboard error
Keyboard error nn
Keyboard locked - Unlock key switch
Monitor type does not match CMOS -
Run SETUP
Operating system not found
Parity Check 1
Parity Check 2
Press <F1> to resume, <F2> to
Setup
Real time clock error
Shadow RAM Failed at offset: nnnn
System battery is dead - Replace and
run SETUP
System cache error - Cache disabled
System CMOS checksum bad - run
SETUP
System RAM Failed at offset: nnnn
System timer error
Page 5-4
Explanation
Drive A: or B: is present but fails the POST diskette tests. Check that the drive is
defined with the proper diskette type in Setup and that the diskette drive is installed
correctly.
Extended memory not working or not configured properly at offset nnnn.
The hex number nnnn is a map of the bits at the RAM address (System, Extended,
or Shadow memory) that failed the memory test. Each 1 in the map indicates a
failed bit.
Fixed disk is not working or not configured properly. Check to see if fixed disk is
installed properly. Run Setup be sure the fixed-disk type is correctly identified.
Type of floppy drive for drive A: not correctly identified in Setup.
Problem with NVRAM (CMOS) access.
The keyboard controller failed test. Try replacing the keyboard.
Keyboard not working.
BIOS discovered a stuck key and displays the scan code nn for the stuck key.
Unlock the system to proceed.
Monitor type not correctly identified in Setup.
Operating system cannot be located on either drive A: or drive C:. Enter Setup and
see if fixed disk and drive A: are properly identified.
Parity error found in the system bus. BIOS attempts to locate the address and
display it on the screen. If it cannot locate the address, it displays ????.
Parity error found in the I/O bus. BIOS attempts to locate the address and display
it on the screen. If it cannot locate the address, it displays ????.
Displayed after any recoverable error message. Press <F1> to start the boot
process or <F2> to enter Setup and change any settings.
Real-time clock fails BIOS test. May require motherboard repair.
Shadow RAM failed at offset nnnn of the 64 KB block at which the error was
detected.
The CMOS clock battery indicator shows the battery is dead. Replace the battery
and run Setup to reconfigure the system.
RAM cache failed the BIOS test. BIOS disabled the cache.
System CMOS RAM has been corrupted or modified incorrectly, perhaps by an
application program that changes data stored in CMOS.
reconfigure the system either by getting the default values and/or making your own
selections.
System RAM failed at offset nnnn of the 64 KB block at which the error was
detected.
The timer test failed. Requires repair of system motherboard.
PC Specialist's Handbook
Edition 1 - Release 1 - March 1998
Run Setup and